Table of Contents
Advertisement
Using the Panic Button
Activate: Press and hold panic button for 2
seconds, the LED will light briefly and the siren will
be activated.
Silence: press and hold panic button for 10
seconds, the LED will light briefly and the siren will
be silenced.
i
Please note that silencing the alarm with the
help button does not disarm the system. If the
alarm is armed prior to activation, the system
will re-arm after being silenced with the help
button.
Using the Smoke Detector
The Smoke Detector will indicate a fire by sounding
its built-in siren, lighting the LED and activating the
external siren and strobe.
-Smoke detection
When smoke is detected the device will activate for
a minimum of 10 seconds with a two tone alarm and
flashing LED for a local fire alarm. The detector will
also activate the external Siren and strobe.
• Pressing the test button when in an alarm
condition will silence the alarm for 10 minutes, it
will automatically resume smoke detection again
after this period.
-Testing
Smoke Detector testing should be done on a regular
monthly basis. Pressing the test button will make
the LED flash, the audible sounder chime and will
send a radio test signal to the Siren when the button
is released. If nothing happens after pressing the
test button then change the batteries.
-Recalibration
The Smoke Detector might need recalibrating after
time to ensure it is working at its optimum. This is
done by pressing and holding in the test button until
the LED flashes and it beeps after 10 seconds. The
detector will then start its self-calibration routine.
10
Key Pad Modes:
Entering setting mode:
Press Panic button A followed by PIN code
. You can now select different function.
default is 0000)
(The LED on the keypad will start flahsing)
Function setting:
Press Panic button A , followed by one of the
following number key:
1 Send learning/testing signal
2 Disable Siren tamper
3 Enable Siren tamper
4 Enter learn mode
(not suitable for first time set-up)
5 Exit learn mode
7 Key Pad to work with control panel based sysem.
8 Key Pad to work with siren based system.
Exiting setting mode:
Press disarm twice.
(The LED will now stop flashing. If not, press disarm twice
again)
Key Fob Modes:
• Sending learn signal
Press any key except the emergency button.
• Siren tamper (Enable)
Press and hold down Arm and emergency for 5
seconds.
• Siren tamper (Disable)
Press and hold down Arm and Home for 5
seconds.
• Learn mode (Enter)
Press and hold down Home and emergency for 5
seconds.
• Learn mode (Exit)
Press and hold down disarm for 5 seconds.
Table 1
(factory
Table 2
Advertisement
Table of Contents
