Minute Minder - Belling 900Ei User Manual

timer selection key again (as long as no
value was set) the next active cooking
zone can be selected.
Setting a timer value
• By pressing the timer keys, a timer
value can be set. If the timer-plus-key is
pressed first the display starts with 1min
and can be increased in 1min steps. If the
timer-minus-key is pressed first the timer
starts with 15 min and can be decreased
in 1 min steps.
• Pressing the key permanently speeds up
the timer adjustment. The speed will also
increase while the key is held. (the time
between two time steps reduces).
• If a timer has expired the timer alarm is
activated and the assigned cooking zone is
immediately switched off.
• The cooking zone display shows 0 or H.
If no user input stops the alarm
signal it will be on for maximum 2
minutes.
The alarm can be deactivated
by switching off the control
using the main switch or by
pressing the two timer keys or
it will be deactivated automatically after 2
minutes.
Switching off a timer or changing the
time setting
The timer value can be modified at any
time by selecting the timer and then by
pressing the (+ or -) timer key.
To stop an active timer the value can be
set to 0. Pressing Plus and Minus simul-
taneously for 2 seconds also resets the
timer value to 0.00.

Minute Minder

The minute minder buzzes when the time
set has expired. It does not switch off any
zone.
USING THE HOB USING THE HOB
To operate:
1) Turn on the hob, using the on/off key.
2) Select the timer by pressing the + and
- keys together (do not activate any cook
zone).
3) Set the right hand digit up to 9 minutes
(Single Minutes Units) and wait a couple
of seconds.
4) The display will now indicate for you to
set the left hand digit, up to 90 minutes
(10 Minute Units).
5) The timer is now set and begins count-
ing down. (No zone indicator light should
be set).
6) You can now use the hob as normal.
When the time is up.
1) The corresponding indicator in the
timer display will flash, the timer will beep.
min
2) Touch any control to stop the beeping.
Warning!
Never leave the hob unattended when in
use, even when you have set the timer to
turn off the cook zone.
Additional timer information
To modify or cancel a timer setting follow
steps 1) to 5) above.
To set the timer for additional zones follow
steps 1) to 5) above.
If multiple zones have been set for timed
operation , the timer display will always
display the time for the cook zone with
the shortest time remaining.
To check the timer setting for a different
cook zone, simply select the required cook
zone, the remaining time will briefly ap-
pear in the timer display.