Before Installation; Fitting The Plinth - Belling 900Ei User Manual

Levelling Your Cooker
Place a spirit level on a baking sheet onto an oven shelf.
The cooker is fitted with leveling feet (1) Level your cooker to your desired height using the leveling feet
at the front and rear of the cooker.
Rear wheels (if fitted)
Adjustment of the wheel height can be made with a screw driver, through the hexagonal hole in the
front plinth

Fitting the plinth

• Make sure the appliance is raised to a height of 915mm or above before beginning. If the appliance
is below 915mm - you can only fit the plinth cover labelled X. You can adjust the height using the
feet (1) of the appliance. If your appliance has a storage drawer at the bottom, you access the re-
quired holes through the base of the drawer after lifting the mat.
• Open the appliance doors, and loosen screw A located on bracket (2). Do not remove this screw
entirely
• Insert screw B, through slot (3) and screw into the small hole at the bottom of bracket (2). Make sure
that the plinth cover is flush to the appliance, but not over tightened.

BEFORE INSTALLATION