Jeep Compass 2018 Owner's Manual page 53

Hide thumbs Also See for Compass 2018:

Table of Contents

Faceplate Knobs

Blower Control

Blower Control is used to regulate the amount of air forced through the climate system. There are seven blower speeds

available. Adjusting the blower will cause automatic mode to switch to manual operation. The speeds can be selected us-

ing either the blower control knob on the faceplate or the buttons on the touchscreen.

Touchscreen Buttons

• Faceplate: The blower speed increases as you turn the blower control knob clockwise from the lowest blower setting.

• Touchscreen: Use the small blower icon to reduce the blower setting and the large blower icon to increase the

Modes Button — If

Modes Button

Push the button in the center of the Blower Control Knob to change the airflow distribution mode. The airflow distribution

mode can be adjusted so air comes from the instrument panel outlets, floor outlets, defrost outlets and demist outlets. The

Mode settings are as follows:

Air comes from the outlets in the instrument panel. Each of these outlets can be individually adjusted to direct the flow of

air. The air vanes of the center outlets and outboard outlets can be moved up and down or side to side to regulate airflow

direction. There is a shut off wheel located below the air vanes to shut off or adjust the amount of airflow from these out-

The blower speed decreases as you turn the blower control knob counterclockwise.

blower setting. Blower can also be selected by pressing the blower bar area between the icons.

Chapters

Table of Contents