Enabling And Disabling The Parksense Active Park Assist System; Parallel Parking Space Assistance Operation/Display - Jeep Compass 2018 Owner's Manual

Enabling And Disabling The
ParkSense Active Park Assist
System
The ParkSense Active Park Assist system can
be enabled and disabled with the ParkSense
Active Park Assist switch, located on the switch
panel below the Uconnect display.
ParkSense Active Park Assist Switch
To enable the ParkSense Active Park Assist
system, push the ParkSense Active Park Assist
switch once (LED turns on).
To disable the ParkSense Active Park Assist
system, push the ParkSense Active Park Assist
switch again (LED turns off).
The ParkSense Active Park Assist system will
turn off automatically for any of the following
conditions:
• The parking maneuver is completed.
• Vehicle speed greater than 18 mph (30 km/h)
when searching for a parking space.
• Vehicle speed greater than 5 mph (7 km/h)
during active steering guidance into the park-
ing space.
• Touching the steering wheel during active
steering guidance into the parking space.
• Pushing the ParkSense Front and Rear Park
Assist switch.
• Driver's door is opened.
• Rear liftgate is opened.
• Electronic Stability Control/Anti-lock Braking
System intervention.
• The ParkSense Active Park Assist system will
allow a maximum number of shifts between
DRIVE and REVERSE. If the maneuver can-
not be completed within the maximum
amount of shifts, the system will cancel and
the instrument cluster display will instruct the
driver to complete the maneuver manually.
The ParkSense Active Park Assist system will
only operate and search for a parking space
when the following conditions are present:
• Gear position is in DRIVE.
• Ignition is in the RUN position.
• ParkSense Active Park Assist switch is
activated.
• Driver's door is closed.
• Rear liftgate is closed.
• Vehicle speed is less than 15 mph (25 km/h).
NOTE:
If the vehicle is driven above approximately
15 mph (25 km/h), the instrument cluster display
will instruct the driver to slow down. If the vehicle
is driven above approximately
(30 km/h), the system will cancel. The driver
must then reactivate the system by pushing the
ParkSense Active Park Assist switch.
• The outer surface and the underside of the front
and rear fascias/bumpers are clean and clear
of snow, ice, mud, dirt or other obstruction.
When pushed, the LED on the ParkSense Ac-
tive Park Assist switch will blink momentarily,
and then the LED will turn off if any of the above
conditions are not present.
Parallel Parking Space Assistance
Operation/Display
When the ParkSense Active Park Assist system
is enabled the "Active ParkSense Searching -
Press or to Switch Maneuver" message
will appear in the instrument cluster display. You
may switch to perpendicular parking if you de-
sire. The arrow buttons on the left side of the
steering wheel can be used to switch parking
maneuvers.
NOTE:
• When searching for a parking space, use the
turn signal indicator to select which side of
the vehicle you want to perform the parking
maneuver. The ParkSense Active Park Assist
system will automatically search for a parking
18 mph
185