Changing Lanesense Status; Parkview Rear Back Up Camera - If Equipped - Jeep Compass 2018 Owner's Manual

Lane Approached (Flashing Yellow
Thick Line, Solid Yellow Thin Line/Flashing
Yellow Telltale
NOTE:
The LaneSense system operates with the simi-
lar behavior for a right lane departure.

Changing LaneSense Status

The LaneSense system has settings to adjust
the intensity of the torque warning (Low/
Medium/High) and the warning zone sensitivity
(Early/Medium/Late) that you can configure
through the Uconnect system screen. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
200
NOTE:
• The system will not apply torque to the steer-
ing wheel whenever a safety system en-
gages. (anti-lock brakes, traction control sys-
tem, electronic stability control, forward
collision warning, etc.).
• Use of the turn signals and Hazard Warning
flashers also suppresses the warnings.
PARKVIEW REAR BACK UP
CAMERA — IF EQUIPPED
)
Your vehicle may be equipped with the
ParkView Rear Back Up Camera that allows you
to see an on-screen image of the rear surround-
ings of your vehicle whenever the gear selector
is put into REVERSE. The image will be dis-
played in the touchscreen display along with a
caution note to "check entire surroundings"
across the top of the screen. After five seconds
this note will disappear. The ParkView camera is
located on the rear of the vehicle above the rear
license plate.
NOTE:
The ParkView Rear Back Up Camera has pro-
grammable modes of operation that may be
selected through the Uconnect System. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen appears
again. When the vehicle is shifted out of RE-
VERSE (with camera delay turned on), the
camera image will continue to be displayed for
up to 10 seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK or the
vehicles ignition is switched to the OFF position.
NOTE:
With Camera Delay turned on, the camera im-
age can be disabled via the Image Defeat (X)
button on the touch screen when the vehicle is
shifted out of REVERSE.
When enabled, active guide lines are overlaid
on the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/receiver.
Different colored zones indicate the distance to
the rear of the vehicle.