Signal Booster Specifications; Power Requirements - Wilson Electronics 801101 Installation Manual

Signal Booster Specifications

Model Number
Connectors
Impedance (input/output)
Dimensions
Weight
Frequency
Passband Gain (nominal)
1
20 dB Bandwidth (nominal)
2
Power output for single cell phone (uplink)
3
Power output (uplink) for multiple
4
cell phones:
Power output for single received channel
(downlink)
Power output for multiple received
4
channels (downlink).
The maximum power is reduced by the
number of channels:
Noise Figure (typical)
Isolation (uplink/downlink)

Power Requirements

Signal Booster Voltage/Current
FCC ID:
IC:
5
Notes:
1 . Nominal gain is the maximum gain at any frequency in the passband .
2 . Nominal bandwidth is the difference between two frequencies that are adjacent to the passband where the amplification is 20 dB lower than the passband
amplification . One of the frequencies is lower than the passband and the other is higher .
3 . The Manufacturer's rated output power of this equipment is for single carrier operation . For situations when multiple carrier signals are present, the rating would
have to be reduced by 3 .5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users . This power reduction is to be
by means of input power or gain reduction and not by an attenuator at the output of the device .
4 . The maximum power for 2 or more simultaneous signals will be reduced by 6 dB every time the number of signals is doubled .
5 . The term "IC" before the radio certification number only signifies that Industry Canada technical specifications were met .
Phone: 866-294-1660
Single Band Cellular
800 MHz Specifications
(uplink/downlink)
(uplink/downlink)
CDMA
GSM
EDGE
AMPS
iDEN
Number of
cell phones
2
3
4
5
6
CDMA
GSM
EDGE
AMPS
iDEN
Number of
channels
2
3
4
5
6
Wilson Electronics, Inc.
®
www .wilsonelectronics .com
801101
FME-Male
50 ohms
5 .5 x 4 .3 x 1 .4 inch or 14 x 10 .8 x 3 .5 cm
1 .32 lbs or 0 .6 kg
824-894 MHz
40 dB / 40 dB
50 MHz / 50 MHz
+33 .3 dBm
+32 .0 dBm
+31 .5 dBm
+31 .6 dBm
Maximum Power
+20 .3 dBm
+16 .8 dBm
+14 .3 dBm
+12 .3 dBm
+10 .8 dBm
+2 .7 dBm
-5 .2 dBm
-3 .1 dBm
-5 .0 dBm
Maximum Power
-2 .5 dBm
-6 .0 dBm
-8 .5 dBm
-10 .5 dBm
-14 .5 dBm
3 .5 dB nominal
> 90 dB
9-14 V, .5 A - 1 .5 A
PWO824W V
4726A-824W V
Fax: 435-656-2432
Single Band iDEN
800 MHz Specifications
804002
806-869 MHz
40 dB / 40 dB max
+32 .0 dBm
+10 .0 dBm
PWO806WV
4726A-806W V
Part #110520 AIG SBMW 028 / 11 .17 .10