Hub Caps/Wheel Covers - If Equipped - RAM 2500 2019 Owner's Manual

Hub Caps/Wheel Covers — If Equipped
The hub caps must be removed before raising the vehicle off
the ground.
CAUTION!
Use extreme caution when removing the front and rear
wheel covers. Damage can occur to the center cap and/or
the wheel if screwdriver type tools are used. A pulling
motion, not a pry off motion, is recommended to remove
the caps.
For 2500/3500 single rear wheel (SRW) models, use the flat
end of the lug wrench to hook and pull off the hub cap. Find
the opening in the hub cap, insert the lug wrench, and pull
off the cap. If you need to pry against the wheel, protect the
wheel surface.
Lug Wrench Insertion Location — Hub Cap
On 3500 models with dual rear wheels (DRW), you must first
remove the hub caps—use the procedure noted for the single
rear wheel. For the wheel covers (wheel skins), insert the flat
end of the lug wrench between the outer edge of the wheel
cover and the wheel. Pry against the wheel to remove the
wheel cover. Repeat this procedure around the wheel until
the cover pops off.
IN CASE OF EMERGENCY 487
6