RAM 2500 2019 Owner's Manual page 145

To move the cleat to any position on the rail, turn the nut
counterclockwise, approximately three turns. Then pull out
on the cleat and slide it to the detent nearest the desired loca-
tion. Make sure the cleat is seated in the detent and tighten
the nut.
Adjustable Cleat Assembly
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
GETTING TO KNOW YOUR VEHICLE
To remove the cleats from the utility rail, remove the end cap
screw located in the center of the end cap, using a #T30 Torx
head driver. Remove the end cap and slide the cleat off the
end of the rail.
Utility Rail End Cap
143
2