Cabletron Systems 6E233-49 SmartSwitch 6000 User Manual page 48

Possible Causes
The 6E233-49 SmartSwitch
detect a looped condition.
Mode switch (7), NVRAM
Reset, was changed
sometime before either
cycling power or pressing
the RESET button, causing
the user-entered parameters
to reset to factory default
settings.
Clear NVRAM was set
through Local Management.
If these troubleshooting tables do not solve any problems that occur with the
NOTE NOTE NOTE NOTE
6E233-49 SmartSwitch, contact Cabletron Systems. Refer to
details.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 4-6 Device Setup Troubleshooting
Instruction
1. Verify that Spanning Tree is enabled. Refer to the Local
Management User's Guide for instructions on setting the
type of STA.
2. Review network design and delete unnecessary loops.
1. Reenter the lost parameters as necessary. Refer to the
Local Management User's Guide for instructions on
configuring the device through Local Management.
2. Call Cabletron Systems if the problem continues.
1. Reenter the lost parameters as necessary. Refer to the
Local Management User's Guide for instructions on
configuring the device through Local Management.
2. Call Cabletron Systems if the problem continues.
Troubleshooting Checklist
Section 1.2 for
Troubleshooting 4-9