Advertisement
PTX10001-20C Quick Start
(Optional) Configure the name of the router. If the name includes spaces, enclose the name in quotation marks (" ").
6.
[edit]
root@# set system host-name host-name
Configure the default gateway.
7.
[edit]
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the router management interface.
8.
[edit]
root@# set interfaces em0 unit 0 family inet address address/prefix-length
NOTE:
The management port em0 is on the port panel and the management port em2 is on the FRU end of the
PTX10001 router.
(Optional) Configure the static routes to remote prefixes with access to the management port.
9.
[edit]
root@# set routing-options static route remote-prefix next-hop destination-IP retain no-readvertise
Enable telnet service.
10.
[edit]
root@# set system services telnet
Enable SSH service.
11.
[edit]
root@# set system services SSH
Commit the configuration to activate it on the router.
12.
[edit]
root@# commit
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the PTX10001 router documentation
at
https://www.juniper.net/documentation/product/en_US/ptx10001
WARNING:
Failure to observe these safety warnings can result in personal injury or death.
Permit only trained and qualified personnel to install or replace router components.
Perform only the procedures described in this quick start and the PTX10001 documentation. Other services must be performed
only by authorized service personnel.
Before installing the router, read the planning instructions in the PTX10001 documentation to make sure that the site meets
power, environmental, and clearance requirements for the router.
4
.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
