Advertisement
Before connecting the router to a power source, read the installation instructions in the PTX10001 documentation.
The PTX10001-20C router weighs approximately 26.8 lbs (12.2 kg). Manually installing the PTX10001-20C router in a rack
requires two people to lift the router and install the mounting screws. To prevent injury, keep your back straight and lift with
your legs, not your back.
If the rack has stabilizing devices, install them in the rack before mounting or servicing the router in the rack.
Before installing or after removing an electrical component, always place it component-side up on a flat antistatic mat or in
an antistatic bag.
Do not work on the router or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including rings, necklaces, and watches. Metal
objects heat up when connected to power and ground and can cause serious burns or become welded to the terminals.
Power Cable Warning (Japanese)
The attached power cable is only for this product. Do not use this cable for another product.
Contacting Juniper Networks
For technical support, see:
http://www.juniper.net/support/requesting-support.html
Juniper Networks, the Juniper Networks logo, Juniper, and Junos are registered trademarks of Juniper Networks, Inc. and/or its affiliates in the United States
and other countries. All other trademarks may be property of their respective owners. Juniper Networks assumes no responsibility for any inaccuracies in this
document. Juniper Networks reserves the right to change, modify, transfer, or otherwise revise this publication without notice. Copyright © 2018 Juniper
Networks, Inc. All rights reserved. Rev. 01, October 2018.
PTX10001-20C Quick Start
Advertisement
