Advertisement
PTX10001-20C Quick Start
Attach the mounting-rail to the router using eight mounting screws.
5.
ALM
SYS
ID
CON
ALM
SYS
ID
MGMT
CON
MGMT
0
1
2
3
4
5
0
6
1
7
2
8
3
9
4
10
5
11
6
12
7
13
8
14
9
15
10
16
11
Repeat Step 4 and Step 5 on the opposite side of the router.
6.
Have one person grasp both sides of the router, lift it, and position it in the rack so that the front bracket is aligned with the
7.
rack holes.
Have a second person secure the front of the router to the rack using four mounting screws (and cage nuts and washers if
8.
your rack requires them.) Tighten the screws.
Continue to support the router while sliding the rear mounting-blades into the channel of the side mounting-rails and securing
9.
the blades to the rack. Use the four mounting screws (and cage nuts and washers if your rack requires them) to attach each
blade to the rack. Tighten the screws.
Ensure that the router chassis is level by verifying that all the screws on the front of the rack are aligned with the screws at the
10.
back of the rack.
ALM
SYS
ID
CON
MGMT
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Attach a grounding cable to earth ground and then attach it to the chassis grounding points (on the side of the chassis).
11.
Part 2: Connect Power to an AC-Powered Router
NOTE:
For instructions on connecting DC power, see the installation instructions in the PTX10001 documentation
at
https://www.juniper.net/documentation/product/en_US/ptx10001
To connect power to a PTX10001 with AC power supplies:
If the AC power source outlet has a power switch, set it to the OFF (0) position.
1.
Insert the coupler end of the power cord into the AC power cord inlet on the AC power supply faceplate.
2.
Push the power cord retainer onto the power cord.
3.
Insert the power cord plug into the power source outlet.
4.
2
17
12
18
13
19
14
15
16
17
18
19
.
Copyright © 2018, Juniper Networks, Inc.
Advertisement
