Sony RM-AV3000T Operating Instructions Manual page 54

Transferring Data between
Commanders (continued)
7
Press the ALL key.
ALL
ALL:
COMPO: Data of a Component
"ALL X" appears on the Mode
Display key, and "ALL" appears on
the left Label key.
8
Confirm that the receiving
Commander is ready for data.
(To set the receiving commander,
follow the procedure on page 56.)
9
Press the "ENTER" key.
During transferring the data,
"c c c c c c c c" flashes.
When the all data has been
successfully transferred, "END"
appears on the right Label key.
54
All data of the Commander
Select button or a Label key
Note
If "NG" appears while sending the data, go
back to Step 5 and continue the operation
or press COMMANDER OFF to stop the
operation.
10
Press COMMANDER OFF.
COMMANDER
OFF
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous setting mode.
Note
Be sure that the receiving Commander is ready
to receive data.
To transfer the data of a
Component Select button or a
Label key
The data of a Component Select button or
a Label key on this Commander (the
settings and learned signals programmed
on the keys and buttons) can be
transferred to a Component Select button
or key on another Sony RM-AV3000T.
1
Follow Steps 1 to 6 on page 53.
2
Press the COMPO key.
COMPO