To program a new series of
operations for the buttons which
have already been set
SYSTEM CONTROL 1 or 3 button:
Erase the factory preset program. See
Erase the program. See page 35.
Select the component to operate
by pressing the Component Select
button (in this case, TV) or the
To change label keys, press the
OTHER button repeatedly until you
obtain the desired component name.
The selected component name is
displayed on the Mode Display key,
and the keys for the selected
Press the key(s) or button(s) for
the desired operation.
If you want to turn on the TV, press
the POWER1 key.
Repeat Steps 4 and 5 and
programme the buttons and keys
for the series of operations.
In this example, press the following
buttons and keys.
When you have programmed all
the keys and buttons, press
With a beep sound, a series of
operating commands is registered and
displayed in order. When the display
of keys for the component of which
key you programmed last appears,
the System Control setting finishes.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
When you have programmed the
buttons on the Commander
The names of buttons on the
Commander which are not on the
LCD touch key display (VOLUME
+/–, MUTING, PROGRAM +/–,
RECALL, MENU, OK, EXIT,
and ) are displayed on the right