To change the function display of
You can select the most suitable function
display among all the displays the key
has, and set it to the key.
After Step 4 (page 20), while
pressing the Mode Display key
(in this case, VCR), press the key
you want to teach repeatedly.
Each time the key is pressed, the
display is changed in order.
When the desired display
appears, release the Mode
Then follow Steps 6 to 8 (page
• You can change the display of a key only
when you programme it using the learning
function. If you want to change the display of
the key that has learned a signal, clear the
signal first (page 25). Then teach the key
again using the above procedure to change its
• If you don't change the display of a key, the
default display is used.
• You cannot change the display of the area of
the numeric keys 1 to 9.
To change the name of the Label
You can change the display of the Label
key to the most suitable name using up
to 8 characters or digits.
After Step 4 (page 20), hold the
Label key of which name you
want to change (for example,
COUNTER) pressed for more
than 2 seconds.
The Commander enters the Label