Blackmagicdesign Videohub Installation And Operation Manual page 34

The additional supporting bridge, short blanking plate and associated screws are available as a
separate package from your Videohub dealer. Torx T8, Torx T10, number 01 and number 02 size
Pozidriv screwdrivers are required to install the additional supporting bridge and the Universal
Videohub 72 Crosspoint card.
1 Ensure power is switched off and disconnected from Universal Videohub 288.
2 Use a number 02 size Pozidriv screwdriver to remove the blanking plate from the right
crosspoint card slot.
3 Use a number 02 size Pozidriv screwdriver to remove the blanking plates from the
interface card slots for SDI ports 73-216.
4 Maneuver the supporting bridge through the crosspoint card slots and rest it flat on the
motherboard, with the card guides facing up, while taking great care to avoid damaging
the multi-pin connectors on the motherboard.
5 Stand the supporting bridge so the holes in its left and right feet are positioned over
the corresponding mounting holes on the motherboard standoffs. The card guides
should face the lower supporting bridge at the bottom of the crosspoint slots.
6 Secure the left and right feet of the supporting bridge with the number 02 size
Pozidriv screws.
7 Secure the left and right legs of the supporting bridge with the two Torx T10 screws as
shown in the accompanying illustration. These screws are installed horizontally.
8 Use a Torx T8 screwdriver to remove the silver catches from the two supporting
bridges at the top and bottom of the left crosspoint slot. In the accompanying
illustration, the letter "A" indicates the location on the left side of the supporting bridges
where the silver catches have been removed. When upgrading to a Universal Videohub
288 Crosspoint card at a later time, you will need to reinstate the silver catches, so
make sure you keep them in a safe place. The silver catches shown at "B" should not
be removed. They will be required if installing a Universal Videohub 288 Crosspoint
card in the right crosspoint card slot in the future.
Universal Videohub Routers 34