Router Control Cable; Power Supply; Building Universal Videohub - Blackmagicdesign Videohub Installation And Operation Manual

A Power Overload light will illuminate on the card if inadequate power is being supplied to the
unit for the number of cards installed.
You will need a number 01 size Pozidriv screwdriver to install the Universal Videohub 288
Crosspoint card.

Router Control Cable

Remote router control is performed via 10/100Base-T Ethernet or serial. If router control is
performed via Ethernet, the integrated Videohub Server is used. This means you only need to
provide an Ethernet cable to connect Universal Videohub 288 to your Ethernet network switch.
Third party router controllers can control Universal Videohub 288 via Ethernet, or as an RS-422
slave device, for router crosspoint switching. Please refer to the Developer Information section
of this manual for Videohub and RS-422 protocols.

Power Supply

When fully populated and running at maximum power consumption, Universal Videohub 288
can be powered by a single Universal Videohub Power Supply.
The Universal Videohub Power Supply package includes a power card with a single
connection to a
1 RU size rack mount chassis which contains the power supply.
The Universal Videohub Power Supply chassis contains a universal power supply for use in all
countries. You will need to provide a standard IEC cord with a C13 connector.
Universal Videohub 288 Crosspoint card
U n iv
e r s a
l V i d
e o h
u b P
Universal Videohub Power Supply includes a power
card, 1 RU chassis and connecting power cable.

Building Universal Videohub 288

25 rack units of space should be reserved for the installation of Universal Videohub 288 and
two rack mount power supply chassis, allowing free space for heat dissipation. Only 23 RU is
required if Universal Videohub 288 is mounted at the top of an open rack as heat can be
dissipated from the top.
o w e
r S u
p p ly
Serial Cable
Standard RJ45 Ethernet Cable
Universal Videohub Routers 27