Universal Videohub Status Led's - Blackmagicdesign Videohub Installation And Operation Manual

Handle
Universal Videohub 288 Crosspoint

Universal Videohub Status LED's

The status LED's marked 'alarm', 'power overload' and 'ref in' provide you with an indication of
the current state of the Blackmagic Universal Videohub 288 Crosspoint. The following LED
conditions provide specific information about the status of the unit.
Red 'alarm' LED:
‚ Off: No error. Normal operation
‚ On: Error condition. Other error. Telnet into device to get error code.
‚ 1 flash: Error condition. Fan failure.
‚ 3 flashes: Error condition. No redundant power supply.
Red 'power overload' LED:
‚ Off: Normal operation. Inactive / Slave mode. This should only be seen on a Blackmagic
Universal Videohub 288 with 2 crosspoints
‚ Slowly blinking: Normal operation. Active / Master mode.
‚ On: Error condition. Power overload. Not enough power is being supplied
White 'ref in' LED:
‚ Off: Normal operation. No reference connected.
‚ On: Normal operation. Reference connected.
TIP Blackmagic Universal Videohub 288 Crosspoint has amber colored LED's
mounted inside the device that should only be visible when the heatsink is
removed for development purposes. However in some cases a dim amber light
may be visible through the hole that has been drilled for the 'alarm' LED. This is
not an error condition.
A healthy Universal Videohub 288 Crosspoint should display the following:
‚ Red 'alarm' LED: Off
‚ Red 'power overload' LED: Slowly blinking or off.
‚ White 'ref in' LED: Solid white or off
Status lights USB 2.0 Alarm GPI
RS-422 router
control
Reference Ethernet
In router control
Universal Videohub Routers
Handle
29