NEC Express 5800 Series Installation Manual page 33

Hide thumbs Also See for Express 5800 Series:

Table of Contents

Chapter 1 Installing OS

Select "Exit Fast!UTIL", and then press Enter.

1-13

Select "Reboot System", and then press Enter to reboot the system.

1-14

2. Configure CPU/IO module 1.

Press the POWER switch on front panel to turn off the server.

Then, disconnect all the power cords from the server.

3. Connect power cords in the following order to start the system from CPU/IO module 1.

(1) Connect a power cord to AC inlet connector B.

(2) Connect a power cord to AC inlet connector A.

Note

Make sure that System POWER LED is unlit before disconnecting the power cord.

Important

Make sure that the PRIMARY LED on CPU/IO module 1 is lit.

Note

If you disconnect a power cord, wait for at least 30 seconds before connecting it again.

Tips

See Chapter 1 (1.2 Preparations for Setup) for AC inlet connector.

Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)

1. Setup Procedure

Table of Contents