Connecting And Configuring Options - NEC Express 5800 Series Installation Manual

Chapter 1 Installing OS
1.12

Connecting and Configuring Options

If there is any optional PCI board or peripheral equipment to connect to NEC Express5800/ft series, turn off
the power to NEC Express5800/ft series, and connect it according to Chapter 2 (5.7 PCI Card) in
Maintenance Guide and the device's instruction.
For how to install and use hard disk drive, see Chapter 2 (2. Disk Operations) in Maintenance Guide.
Immediately after the installation completes, network configuration for a port is duplicated. When you change
the network configuration or configure the duplication setting by adding a LAN card, it is necessary to
configure the settings from vSphere Client.
For detailed procedures, refer to the User's Guide and VMware vSphere documents packaged with this guide
from the following Website by selecting "Release 5.5"
http://www.vmware.com/support/pubs/vsphere-esxi-vcenter-server-pubs.html
* The contents of this web site is subject to change or delete without notice.
For how to configure the duplicated network, see Chapter 2 (3. Duplex LAN Configuration) in Maintenance
Guide.
To have enough time to initialize Fibre Channel disk and Fibre Channel switch and so on, adjust [Server] -
[Power On Delay Time] by setting System BIOS configuration Utility.
58
Express5800/R320d-E4, R320d-M4 Installation Guide (VMware 5.5)
1. Setup Procedure