Seam Pattern Input On Sub-Class -9 - Pfaff 3307-3 Series Instruction Manual

11 Seam pattern input on sub-class -9/.. machines
.02
●
Switch on the machine.
●
Select the program number and button type, see Chapter 9.03.01 Selecting the button
type and program number.
●
Call up the programming mode
●
Select the desired parameter (P01, P02 etc.) with the left +/- keys.
●
With the two corresponding +/- keys move to or select the desired positions (X and Y)
or values.
Parameter input for stem wrapping
●
Operate the left +/- keys to take over the values entered and to call up the next or
previous parameter.
●
Press the "programming" key to take over the values entered and to call up the sewing
mode.
No X
P 0 1 - 1 0
P01 Cross stitch position material side
P02 Cross stitch position button side
P07 Total number of stitches (1-99)
To achieve the best results, cutting should take place at the left needle entry
position. This is achieved through the number of stitches and the location of the
needle entry positions.
Y
2 0
Input
53