Table of Contents
Advertisement
Input
11
Seam pattern input for three-hole buttons
.01.02
● Switch on the machine.
● Select the program number and button type, see Chapter 9.03.01 Selecting the button
● Call up the programming mode
● Select the desired parameter (P01, P02 etc.) with the left +/- keys.
● With the two corresponding +/- keys move to or select the desired positions (X and Y)
Parameter input three-hole button
● Operate the left +/- keys to take over the values entered and to call up the next or
● Press the "programming" key to take over the values entered and to call up the sewing
Seam pattern for the three-hole button
48
type and program number.
No
P 0 1
or values.
P01
P02
P03
P07
P09
P10
previous parameter.
mode.
To achieve the best results, cutting should take place at the left needle entry
position. This is achieved through the number of stitches and the location of the
needle entry positions.
Seam cycle
1
(P09 = 1)
3
2
Point
1
(P09 = 2)
3
2
Basting
2
1
(P09 = 3)
3
X
Y
- 1 0
2 0
First needle entry position
Second needle entry position
Third needle entry position
Total number of stitches (2-99)
Seam pattern:1 = seam cycle, 2 = point, 3 = basting
End knotting function: I = off, II = on
Advertisement
Table of Contents
