Selecting A Seam Program; Selecting And Changing The Seam Pattern - Pfaff 3371-1 series Instruction Manual

9

Selecting a seam program

.06
To avoid the machine starting accidentally, to begin with the TE
TE
the machine has been switched on. The machine is then in its basic position and offers a
number of possibilities for selecting seam programs.
- Direct selection of the seam pattern and its individual adaptation by changing the speed
and size factors.
- Selection of the seam program via a program station. For this purpose a seam pattern
with its respective speed and corresponding size factors must have been stored
previously.
- With the selection of a sequence several seam programs are sewn after each other. For
this purpose a sequence must have been compiled beforehand from individual seam
programs (program stations).
9

Selecting and changing the seam pattern.

.06.01
With the machine in the basic position, select the direct seam pattern.
P
11 With the corresponding plus/minus key select the desired seam pattern, e.g. 11. The
seam patterns are stored in the machine under program numbers, see Chapter 11.05
Summary of the seam patterns.
2700
Select the desired speed with the corresponding plus/minus key.
X 100
Enter the desired size factor (in %) (X-direction) with the corresponding plus/minus key.
Y 100
Enter the desired size factor (in %) (Y-direction) with the corresponding plus/minus key.
TE
Conclude the input by pressing the TE key. (The machine changes to the sewing mode).
P7
P1 P2 P3 P4 P5 P6
X Y
11 2700 100 100
The enlargement of the seam pattern is limited by the size of the machine's
sewing area.
The altered speed and size factors entered are not stored when the machine
changes to another seam program. If you wish to store these values, a station
key must be reserved with the corresponding seam program, see Chapter
11.01 Reserving program stations.
P8
P
C1
C2
C3
TE
Setting up
TE TE key must be pressed, after TE TE
9 - 5