Input
11
Free input of the seam pattern
.04
In addition to the selection of firmly stored seam patterns (see Chapter 11.06 Summary of
the seam patterns), there is also a possibility of setting seam patterns (button type) as desi-
red using the corresponding parameter input.
●
●
●
●
●
●
●
●
42
The program numbers P50 to P99 are reserved for the free input of seam pat-
terns.
Call up the Input mode by pressing the TE key (LED is illuminated).
No
001
With the corresponding +/- keys, select the parameter 201 to enter the program number.
No
201
With the corresponding +/- keys, select the desired program number.
With the corresponding +/- keys, select the parameter 202 to enter the button type.
With the corresponding +/- keys, select the desired button type.
(2 = two-hole button, 3 = three-hole button, 4 = four-hole button)
With the corresponding +/- keys, select the parameters 203 - 208 in turn to enter the co-
ordinates of the buttonholes 1 - 6, and enter the relevant values for the X- and Y-direction.
If necessary, with the corresponding +/- keys, select the parameter 209 to enter the
number of stitch positions and enter the desired value.
If necessary, with the corresponding +/- keys, select the parameter 210 to choose the
stitch formation.
The stitch formation can only be chosen for three- and four-hole buttons and depends on
the previously selected button type.
)
(Teach in)
VAL
2500
VAL
50