Ingenico Move 5000 User Manual page 18

Bluetooth Base: Used for charging the terminal battery and has ports to
allow terminals to communicate with hosts over Ethernet.
It is needed if you want to communicate with the base via BT and then use
the LAN to connect to remote host.
You should set up your base unit in a convenient location close to a power source
and network point.
To open the base unit cover, located on the bottom of the base unit, you must
unclip an access clip and lift the cover from the base unit. To replace the cover
reverse these instructions being sure to engage all the retaining pins before the
access clips.
Terminal
charging points
Terminal
Ethernet Port USB Ports
guides
Power
socket
Page 18
Copyright© 2019 Ingenico
Move/5000 User Guide