In all cases the unit must be level to within plus or minus one-quarter inch end-to-end and plus
or minus one-either inch side-to-side for proper operation. Locate the unit as close to the wine
room as possible to reduce the length of the duct runs. If possible, use short and straight ducting
on all ductwork runs.
Typical Mounting Arrangements
The following illustrations are suggested mounting arrangements. These illustrations are not
intended to be complete and detailed installation drawings. For questions or help regarding
installation, contact a Wine Guardian PRO Split System distributor or email
(info@wineguardian.com) a sketch of the proposed area where the unit is to be installed.
Handling and Installation
1) Mount unit on solid, level surface.
2) Allow sufficient space for access to unit and accessories.
3) Provide proper electrical service.
4) Provide water to humidifier.
5) Install drain line with proper pitch.
Floor Mount
Supply air at ceiling, low wall return
Fig. 1
31