Configuring The Network Settings Of The Receiver - Sony STR-DN2010 Manual de instrucciones Operating Instructions Manual

Configuring the network
settings of the receiver
The network settings for the receiver must be
set correctly to use the network functions of
the receiver.
You can make the required network settings
for the receiver by following the instructions
provided by an initial setup wizard.
The procedure used to set up the IP address
automatically (DHCP) is explained below.
In this case, the router that is connected to the
receiver or the Internet provider must support
DHCP.
1
Press GUI MODE.
After "GUI ON" appears on the display
for a while, the GUI menu appears on the
TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
2
Press V/v repeatedly to select
" Settings", then press
b.
3
Press V/v repeatedly to select
"Network", then press
4
Press V/v repeatedly to select
"Network Setup", then press
.
"Start Network function Setup Wizard"
appears on the TV screen.
5
Press
6
Press
Automatically (DHCP)".
"Success! The receiver is now connected
to network." appears on the TV screen
when you have succeeded in making a
connection.
If the failure screen is displayed, perform
the process referring to "Network Setup"
(page 118), after you have completed this
process.
7
Press
To set the network settings
manually
See "To set the IP address manually"
(page 118) or "To set the Proxy server
manually" (page 119).
V/v/b,
Note
The wizard screen appears on the TV screen each
time you use the network function, until the network
function setup has been completed.
MENU
or
.
to select "Next".
to select "Connect
to select "Finish".
GB
49