Sony STR-DN2010 Manual de instrucciones Operating Instructions Manual page 46

* When the speaker(s) is (are) out of the phase,
"Out" is displayed on the TV screen. The "+"
and "–" terminals of the speaker may be
connected the other way around.
However, depending on the speakers, "Out"
appears on the TV screen even though the
speakers are connected properly. This is
because of the speakers' specifications. In
this case, you can continue to use the
receiver.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• You can change the unit of distance in "Distance
Unit" in the Speaker settings menu (page 113).
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
– Press ?/1.
– Press the input buttons on the remote or
press the INPUT SELECTOR +/–
repeatedly on the receiver.
– Press MUTING (RM-AAP055 only) or
(RM-AAP056 only) on the remote. Press
MUTING on the receiver.
– Press SPEAKERS on the receiver.
– Change the volume level.
– Connect the headphones.
3: Saving the measurement
results
To save the measurement results obtained in
"2: Performing Auto Calibration" (page 44),
proceed with the following steps.
1
Press V/v to select "Save" in
step 7 in "2: Performing Auto
Calibration" (page 45), then
press .
The selecting screen of the calibration
type appears.
GB
46
2
Press V/v repeatedly to select
the calibration type, then press
.
• Full Flat
Makes the measurement of frequency
from each speaker flat.
• Engineer
Sets the frequency to one that matches
that of the Sony listening room
standard.
• Front Reference
Adjusts the characteristics of all the
speakers to match the characteristics of
the front speaker.
• OFF
Sets the Auto Calibration equalizer
level to off.
The measurement results are saved.
3
Disconnect the optimizer
microphone after you have
finished.
Note
If you have reposition your speaker, we recommend
that you perform Auto Calibration again to enjoy the
surround sound.
Tip
The size of a speaker ("Large"/"Small") is
determined by the low frequency characteristics.
The measurement results may vary, depending on
the position of the optimizer microphone and
speakers, and the shape of the room. It is
recommended that you follow the measurement
results. However, you can change those settings in
the Speaker Settings menu. Save the measurement
results first, then try to change the settings if you
want.