Network Standby - Sony STR-DN2010 Manual de instrucciones Operating Instructions Manual

To cancel the setup
Press V/v repeatedly to select "Cancel", then
press in step 3.
To remove the detected
controllers from the list
1
Press V/v repeatedly to select the
controller you want to remove from the
list, then press
2
Press V/v repeatedly to select
"Remove All", then press
Tip
Up to 10 network controllers that have attempted to
access the receiver are listed, and each of them can
control the receiver.
Device Name
Lets you assign a device name to the receiver
up to 20 characters displayed as being on the
home network.
To assign the device name
1
Press V/v repeatedly to select "Device
Name", then press
2
Press .
The soft keyboard appears on the TV
screen.
3
Press V/v/B/b and
character one by one to enter the
device name.
4
Press V/v/B/b repeatedly to select
"Finish", then press
When the setting is applied to the receiver,
the receiver will restart automatically.
Tip
The default device name is "STR-DN2010".
GB
120
to check the box.
.
.
to select a
.
Rhapsody Account
Lets you enter the Rhapsody Account to listen
to the Rhapsody Internet radio service. For
details, see "Setting an account" (page 83).
Rhapsody is only available in the U.S.

Network Standby

Lets you turn the function that activates the
switching hubs on the rear of the receiver and
allows external control devices to control the
receiver on or off even when the receiver is in
standby mode.
x OFF
The network function turns off when the
receiver is in standby mode.
x ON
The network function works even when the
receiver is in standby mode.
In addition, the start-up time of the network
function is reduced after the receiver is turned
on.
Note
When the receiver is in standby mode,
"A. STANDBY" appears on the display if "Network
Standby" is set to "ON".