Enjoying The System's Sound In Another Room - Sony STR-DN2010 Manual de instrucciones Operating Instructions Manual

Notes
• Perform pairing within 5 minutes in step 7. If
you do not, pairing is recognized as failed,
and the screen changes accordingly. In this
case, see "If pairing fails" (page 98).
• When sound transmission is established,
"Pairing complete. To perform pairing to
another unit, select "Continue"." appears.
9
Press B/b repeatedly to select
"Finish" or "Continue", then
press .
• "Finish": Finishes pairing.
• "Continue": Continues to perform
pairing to another S-AIR sub unit.
Tip
You can confirm the pairing completion or the
current ID by checking the "S-AIR Settings"
screen. "(Pairing)" appears beside the current
S-AIR ID.
10
Press GUI MODE.
The GUI menu turns off.
Note
After you have performed pairing, if you select the
"S-AIR ID" menu, the ID setting ("A", "B" or "C")
that you last used is displayed.
If pairing fails
"Pairing failed. Retry?" appears.
To perform pairing again, select "Yes".
To finish pairing, select "No".
To quit pairing during setting
Press RETURN/EXIT O.
To cancel pairing
Perform the ID setting of the main unit
according to the procedure of "To set the ID of
the S-AIR main unit" (page 95). If you reset
the ID (even the same ID again), pairing is
canceled.
GB
98
Enjoying the system's
sound in another room
(For the S-AIR receiver only (not
supplied))
You can enjoy the system's sound in another
room by using the S-AIR receiver. The S-AIR
receiver can be placed in another room for
enjoying the system's sound there.
For details of the S-AIR receiver, refer to the
operating instructions supplied with the S-AIR
receiver.
1
Set the ID of the S-AIR receiver
to match the ID of the S-AIR
main unit.
• To set the ID of the S-AIR main unit,
see "To set the ID of the S-AIR main
unit" (page 95).
• To set the ID of the S-AIR receiver,
refer to the operating instructions
supplied with the S-AIR receiver.
Notes
• When you are using another S-AIR sub unit,
such as a surround amplifier, do not change
the ID of the S-AIR main unit. Set the ID of
the S-AIR receiver to match the ID of the
S-AIR main unit.
• When you pair the S-AIR main unit and
another S-AIR sub unit, such as a surround
amplifier, you also need to pair the S-AIR
main unit and the S-AIR receiver. For details,
see "Pairing the S-AIR main unit with a
specific S-AIR sub unit (Pairing operation)"
(page 96).
GUI MODE
V/v/b,
MENU