Replacing The Filter Element In The Fluid Filter - HYDAC International FluidAqua Mobil FAM 15-P Operating And Maintenance Instructions Manual

FluidAqua Mobil - FAM 10/15-P

Replacing the filter element in the fluid filter

As soon as the error message "change fluid filter" appears on the display the filter
should be taken out of the housing and be replaced by a new one.
The contaminated filter must to be disposed of according to the local regulations as
hazardous waste.
To change the filter element, proceed as follows:
1. Switch off the system and close the locking
devices at the inlet and outlet ports
Make sure that the unit cannot be
inadvertently switched back on during
maintenance work.
2. Put a suitable container (1) in place to catch
escaping operating medium.
Depressurize the filter housing.
Carefully open the drain plug (2) on the filter
bowl and empty the filter housing completely
using the drain screw (6mm) on the bottom
of the filter housing.
The volume is ~ 2 liters.
After draining, replace the drain plug on the
filter bowl.
3. Undo the tensioning clamp (1) on the filter
housing and then remove the housing by
moving it downwards (2).
Use a 6 mm Allen wrench (1).
HYDAC FILTER SYSTEMS GMBH
BEWA FAM10-15-P 3193324b en-us 2011-01-19.doc
en(us)
Performing maintenance
Page 65 / 80
2011-01-19