Installing The Intellibrite Light Assembly, New Gasket/Uni-Tension Wire Clamp - Pentair IntelliBrite 5G Installation And User Manual

4. INSTALL UNI-TENSION WIRE CLAMP: With the hook ends of the circular
Uni-Tension Wire Clamp pointing down, spread the clamp and place it in the "U"
recesses of the locking levers. Be sure the hook ends of the clamp are located
between the pair of locking levers as shown below and that the wire clamp is
properly engaged with all of the lock levers.
5. Place a cloth on the ground to protect the lens. Turn the light over so the lens
is resting on the cloth. Be sure the orientation of the wire clamp and the bolt
connection is positioned at 45°.
6. Tighten the bolt and nut until both ends meet (touching is optimal). Note: A
tolerance distance of 3/16" (4.8 mm) or less between the ends of the clamp.
Continue on next page.
"TOP" label
(use to align light
housing with pilot
screw on face
PILOT
SCREW
Position the wire clamp (nut and bolt) about 45°
between the PILOT SCREW and BOLT/NUT.
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
PILOT SCREW
(12 o'clock)
"W" ON LENS
BRASS NUT
Align letter "W" ("WIDE"
angle) on lens/gasket
with pilot screw hole on
face ring and brass nut
For "NARROW" angle
light beam, rotate "N" to
12 o'clock position
3/16 in (0.5 cm) or less
17
Uni-tension
Wire Clamp
Lock
lever