Pentair IntelliBrite 5G Installation And User Manual page 25

Replacing the IntelliBrite
Note: When replacing an IntelliBrite 5G Spa light assembly, a new
spa light assembly includes a light engine, lens, gasket, uni-tension
wire clamp, and face ring (for part numbers, see page 25).
1. Turn off main electrical switch or circuit breaker, as well as the switch
which operates the IntelliBrite underwater light itself.
Note: DO NOT
the light on the deck.
Failure to do so may permit water to leak into the assembly which could cause: (a)
an electrical hazard resulting in death or serious injury to pool users, installers, or
others due to electrical shock, or (b) breakage of the lens, which likewise could result
in serious injury to pool users, installers, or bystanders, or in damage to property.
2. REMOVING THE INTELLIBRITE SPA LIGHT: Remove the pilot screw at top
of face ring, remove the light assembly from the niche. Place the assembly
on the deck. Note: It is not necessary to drain down the pool.
the mounting ring and wet niche. Failure to use the screw provided could create an
electrical hazard which could result in death or serious injury to pool users, installers
or others due to electrical shock.
(in an existing pool)
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Always disconnect power to the pool light at the circuit breaker
before servicing the light. Failure to do so could result in death
or serious injury to installer, pool professional, pool users, or
others due to electrical shock.
service the light while in the pool water. Service
Always install a new lens gasket (P/N 79108600) and uni-tension
wire clamp. Whenever disassembling the IntelliBrite light assembly.
Pilot screw (bronze
or stainless steel)
IntelliBrite 5G Spa Light
Be sure to keep the pilot screw from the IntelliBrite light.
This screw mounts and electrically grounds the housing securely to
INTELLIBRITE
®
Spa Light Gasket
D A N G E R !
5G Pool and Spa Lights Installation and User's Guide
®
21