Pentair IntelliBrite 5G Installation And User Manual page 16

12
REPLACING THE INTELLIBRITE POOL LIGHT CIRCUIT BOARD
When replacing the IntelliBrite Pool Circuit Board, the Unit-Tension
Wire Clamp (P/N 600095), (Gasket (P/N 620400Z) or Gasket and Lens
(619864Z) MUST ALSO BE REPLACED - SEE PAGE 20 FOR PART
NUMBERS.
Removal and Installation of IntelliBrite 5G Light Circuit Board
1. Turn off main electrical switch or circuit breaker, as well as the switch which
operates the IntelliBrite light itself. Note: DO NOT
the pool water. Service the light on the deck.
2. Before starting be sure that you have a new lens gasket (P/N 620400Z),
Uni-Tension Wire Clamp (P/N 600095) and a IntelliBrite 5G pool light circuit
board assembly (P/N 619875Z - 300w, P/N 619916Z-400W, P/N 619917Z-
500w) - P/N 619818Z (Color) ready to install.
the same type will damage the light assembly and may cause an electrical hazard
resulting in death or serious injury to pool users, installers, or others due to
electrical shock, and may also cause damage to property.
light assembly. Failure to do so may permit water to leak into the assembly which
could cause:
(a) an electrical hazard resulting in death or serious injury to pool users, installers,
or others due to electrical shock, or
(b) breakage of the lens, which likewise could result in serious injury to pool users,
installers, or bystanders, or in damage to property.
3. REMOVING THE INTELLIBRITE 5G POOL LIGHT ASSEMBLY: Remove
the pilot screw at top of face ring, remove the light assembly from the niche.
Place the assembly on the deck. Note: It is not necessary to drain down the
pool.
4. Unwind the cord from the base of the light housing.
ASSEMBLY (IN AN EXISTING POOL)
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
Always disconnect power to the pool light at the circuit breaker
before servicing the light. Failure to do so could result in death
or serious injury to installer, service person, pool users, or
others due to electrical shock.
Replace the light circuit board assembly with the same type and
wattage. Failure to replace the light circuit board assembly with
Always install a new lens gasket (P/N 620400Z) and
Wire Clamp (P/N 600095)
D A N G E R !
service the light while in
whenever disassembling the IntelliBrite
Uni-Tension
Pilot screw (bronze
or stainless steel)
IntelliBrite 5G Pool Light