Pentair IntelliBrite 5G Installation And User Manual page 17

REPLACING THE INTELLIBRITE
ASSEMBLY (IN AN EXISTING POOL) (Continued)
5. Place a cloth on the ground to
protect the lens. Turn the light
over so the lens is resting on
the cloth. Using a 1/4 in (0.64
cm) nut driver and a #3 Phillips
screwdriver, remove the nut from
the Uni-Tension Wire Clamp.
Place the nut aside for
reinstallation.
6. Remove the face ring and
wire clamp from the light
housing. Discard the
Uni-Tension Wire Clamp.
7. With the light resting on
its base, carefully pry off
the gasket to remove the
lens. Set the lens aside for
installation later. Discard
the gasket.
Note: A NEW LENS
GASKET (P/N 620400Z)
AND UNI-TENSION WIRE
CLAMP MUST BE USED
EACH TIME THE LIGHT IS
REASSEMBLED.
See page 20 for
Replacement Kit part
numbers.
Note: Note the current position of the lens at the pilot screw (12 o'clock)
position, before removing it from the fixture. "W" on the lens indicates wide
angle, "N" indicates narrow angle. For more information, see page 17 and 19.
NOTE: For a pool light (12 V only, no internal step-down transformer)
that has a replacement FUSE ASSEMBLY, continue the procedure on
the next page. If the light does NOT have a replacable fuse assembly,
proceed to page 15.
®
POOL LIGHT CIRCUIT BOARD
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
13
Gasket
Lens
Uni-Tension
Wire Clamp:
Remove nut
and screw,
Save nut for
reinstallation.
Face ring