Pentair IntelliBrite 5G Installation And User Manual page 20

16
INSTALLING THE INTELLIBRITE
GASKET AND UNI-TENSION WIRE CLAMP (Continued)
Install NEW GASKET ONTO
1.
LENS: Stretch the gasket
around the circumference of
the lens. Be sure the gasket is
installed evenly around the lens.
IMPORTANT NOTE: Install the
gasket so that the flat edge
side of the gasket is towards
the inner surface of the face
ring and the Black embedded
o-ring must be between the
lens and the light housing.
Note: The letters TOP are
embossed on the flat edge
side of the gasket.
ALIGN THE LENS/GASKET ON
2.
TO THE LIGHT HOUSING:
a) With the light housing
resting on its base, place the
lens/gasket on top of the light
housing.
b) Rotate the lens/gasket to
align the letter "W" ("WIDE"
angle) on the lens with the
brass nut in the housing (see
diagram on page 17 for brass
nut location).
INSTALL THE FACE RING:
3.
Place the face ring on top of
the lens/gasket/housing. Rotate
the face ring so the pilot screw
hole is aligned in the 12 o'clock
position, with the lens letter "W"
(or "N") and the brass nut in the
housing. Also, verify the "TOP"
position arrow indicator label
(see page 17) on the rear of the
housing is aligned with the pilot
screw on the face ring.
Note: The IntelliBrite light lens ships from the factory in the 'WIDE' (W) angle
position. The "wide" position of the lens is typically used for lights located either
side of the pool. The "narrow" position of the lens is typically used for lights located
either end of the pool. To use the "NARROW" angle light beam, rotate the lens/
gasket to align the letter "N" on lens. Note: For more information about the "WIDE"
and NARROW angle lens position, see page 19.
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
POOL LIGHT ASSEMBLY WITH NEW
®
GASKET
UNI-TENSION
WIRE CLAMP
INSDIE OF
FACE RING
HOUSING
Uni-Tension
Wire Clamp
FACE RING
LIGHT HOUSING
BLACK
O-RING
LENS
LIGHT
Gasket
(Flat edge
towards the
GASKET
face ring
- TOP is
embossed
on the top
side of the
LENS
gasket)
Gasket
flat edge
is towards
the inner
surface of
face ring