Pentair IntelliBrite 5G Installation And User Manual page 28

24
11. INSTALL THE NEW UNI-TENSION WIRE CLAMP: With the hook ends of the
circular uni-tension wire clamp pointing down, spread the clamp and place it in
the "U" recesses of the locking levers. Be sure the hook ends of the clamp are
located between the pair of locking levers as shown below and that the wire
clamp is properly engaged with all of the lock levers.
12. Place a cloth on the deck to protect the lens. Turn the light over so the lens
is resting on the cloth. Be sure the orientation of the wire clamp and the bolt
connection is positioned at 90°. Tighten the bolt and nut until the distance
between the ends of the clamp equals 1/4 in (0.64 cm) or less.
13. PROCEED TO "Installing the IntelliBrite
(after electrical requirements are met)" on page 4 for spa light fixture
installation instructions.
Bolt
(and Hook ends)
Lock lever
(x4)
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
®
5G Pool and Spa Light Fixture
Orientation of bolt and wire clamp
Tighten nut and bolt about 90˚ from
the Pilot Screw between the lock levers.
IntelliBrite
Spa light
assembly
Gasket
Lens
Uni-tension
wire clamp
Screw
Nut (Pilot screw)
Face ring
Pilot screw
(bronze or
stainless steel