Replacing The Intellibrite 5G Pool And Spa Light Assembly - Pentair INTELLIBRITE 5G Installation And User Manual

To select a color light show mode or fixed color mode, rotate the dial so that it points to
the desired selection.
Hold and Recall Feature:
previously selected color will be displayed, unless the HOLD or RECALL feature was
previously enabled.
Hold button/LED: Press this button (LED on) to capture and save a color effect while
displaying one of the light show modes. When the button is pressed, the LED will be on,
indicating that the color effect is captured.
Recall Button/LED: Use this button (LED on) to activate the last saved color effect.
When the button is pressed, the LED will be on, indicating that the color effect is being
displayed.
Replacing the IntelliBrite
Light Assembly (in an existing pool or spa)
Verify that the pool and spa meets the requirements of the current National Electrical Code
and all local codes and ordinances. A licensed or certified electrician must install the
electrical system to meet or exceed those requirements before the underwater light is
installed. Some of the requirements of the National Electrical Code which the pool's
electrical system must meet are as follows:
• The lighting circuit has a Ground Fault Circuit Interrupter (GFCI) for line voltage
models, and has an appropriately rated circuit breaker.
• The Junction Box (or, for 12 volt models, the low voltage transformer) is located
at least eight (8) inches (20.3 cm) above ground level and at least 48 inches
(1.219 m) from the edge of the pool; see Figure 1 on page 7.
• The light fixture and all metal items within five (5) feet (1.524 m) of the pool are
properly electrically bonded.
• The wet niche is properly installed so that the top edge of the underwater light's
lens is at least 18 inches below the surface of the water in the pool; see Figure 1
on page 7.
• The wet niche is properly electrically bonded and grounded via the No. 8 AWG
ground connector located at the rear of the niche; see Figure 1 on page 7.
•
To be certain that the pool's electrical system meets all applicable
requirements, the electrician should also consult the local building
department. Note: Use only Pentair wet niches to insure proper bonding and
grounding connections.
When IntelliBrite color lights are powered on, the
Risk of Electrical Shock or Electrocution!
This underwater light must be installed by a licensed or certified
electrician or a qualified pool professional in accordance with
the National Electrical Code and all applicable local codes and
ordinances. Improper installation will create an electrical hazard
which could result in death or serious injury to pool users,
installers or others due to electrical shock, and may also cause
damage to property. Always disconnect the power to the pool
light at the circuit breaker before servicing the light. Failure to
do so could result in death or serious injury to serviceman, pool
users or others due to electrical shock.
INTELLIBRITE
®
5G Pool and Spa
5G Pool and Spa Lights Installation and User's Guide
®
3