Pentair IntelliBrite 5G Installation And User Manual page 27

6. INSTALLING THE INTELLIBRITE
UNI-TENSION WIRE CLAMP: Install a new gasket and uni-tension wire
clamp when assembling the IntelliBrite spa light assembly. A NEW LENS
GASKET AND UNI-TENSION WIRE CLAMP MUST BE INSTALLED EACH
TIME THE LIGHT IS REASSEMBLED.
7. Install the new gasket onto the lens: With the light housing resting on its
base, place the lens then the gasket on top of the light housing.
8. INSTALL FACE RING: Place the face ring on top of the lens/gasket/housing.
Rotate the light housing to align the "TOP" position arrow indicator label on
the rear of the housing is aligned with the pilot screw on the face ring. Place
the face ring on top of the gasket. Make sure that the lens and gasket are
centered correctly on the light housing.
PILOT
SCREW
9. Aligning the face ring and lens: Align the face ring and vertical line on the
lens so that the letter "O" in the word "TOP" and the small arrow above it) on
the surface of the lens points to the 12 o'clock position and with pilot screw
hole on the face ring.
Align letter "O" in
the word "TOP"
on lens with pilot
screw hole on
face ring
Align vertical line
on lens to point
to the pilot screw
hole
®
SPA LIGHT WITH NEW GASKET AND
INTELLIBRITE 5G Pool and Spa Lights Installation and User's Guide
®
TOP
23
Pilot screw
(bronze or
stainless
steel