Programming The Remote - Sony 3-875-814-11(1) Operating Instructions Manual

Programming the remote

You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
The procedure below uses as an example a
case in which a VCR made by a company other
than Sony is connected to the VIDEO 2 IN
jacks on the receiver.
Main remote
RM SET
UP
SHIFT
Numeric
buttons
Zone 2/Zone 3 remote
RM SET
UP
SHIFT
Numeric
buttons
1
Press AV ?/1 while pressing RM
SET UP.
The RM SET UP button flashes.
2
While the RM SET UP button is
flashing, press the input button
(including TV) for the
component you want to control.
For example, if you are going to control a
VCR connected to VIDEO 2 IN jack,
press VIDEO 2.
RM SET UP and the input button light up.
If you press the button for a component of
which you cannot program the remote,
such as TUNER, PHONO, DMPORT or
SOURCE, etc., the RM SET UP button
keeps flashing.
3
Press the numeric buttons to
enter the numeric code (or one
AV ?/1
of the codes if more than one
code exists) corresponding to
the component and the maker
Input
of the component you want to
buttons
control.
The input button lights up.
Note
ENT/
For a TV remote code value, only numbers in
MEM
the 500's are valid.
4
Press ENT/MEM or ENTER.
Once the numeric code has been verified,
the RM SET UP button flashes twice and
the remote automatically exits the
AV ?/1
programming mode. The input button
also turns off.
To cancel programming
Press RM SET UP during any step.
ENTER
137 GB