Table of Contents
Advertisement
Programming the Remote
The DSS receiver's
remote
control
is preset
at tile factory
to operate
Sony
brand
TVs.
If you have
a TV other
than
Sony brand,
or you have
a cable box, VCR,
or laserdisc
player
that you want
to control
with
the DSS receiver's
remote,
use the following
procedures
to program
the remote
to control
these
components.
Note
Your components must have infrared (IR) remote control capability in order to
be used with the DSS receiver's remote.
To program
the DSS receiver's
remote:
1
2
You mitst pcJdbrm step 4 within 10
3
seconds of step 3, or you must start
4
again from step 3.
You must perform step 5 within 10
seconds of step 4, or you must start
again from step 3. To cancel the
operation, press the ENTER button.
Manually
turn on the component
that you want to program.
Turn to "Programmable
Codes" on page 80 through
page 81, and
find the three-digit
code number
for your component.
If more than
one code number
is listed, use the number
listed first to complete
the following procedures.
Press the CODE SET button.
Press the FUNCTION
button
(CABLE or TV) for the component
you're setting up. To set up a VCR or laser-disc
player, set the slide
switch to any position
(VTR1/2/3/MDP).
5
Enter the three-digit
code number.
6
Press the ENTER button.
To Check if the Code Number Works
Use the following
procedure
to make sure the code you've entered
works:
1
Aim the DSS receiver's
remote at the component
and press the
POWER button that corresponds
to that component.
If the component
responds,
try the CH+ and CH- buttons.
If the
component
responds,
you're done. If the code doesn't
work:
Try programming
the remote using the other codes listed for your
component.
If you cannot get your component
to respond
to the DSS receiver's
remote -- even after trying all the code numbers
for your
component
-- follow the procedure
described
in "Using the Learn
Function"
on page 82.
Appendix: Other
Information
79
Advertisement
Table of Contents
