commander codes that
are not stored in the
Even if a remote commander code is not one of
the presets stored in the remote, it is possible
for the remote to learn the code using the
When setting up the receiver to learn the remote
command modes, replace the batteries with new
Example for storing a new commander code
for the numeric button 1 when the VIDEO2
input is selected.
Press THEATER while pressing
RM SET UP.
The RM SET UP button lights up.
Press the input button (VIDEO2
in the example) for the
component you want to operate
with the new command.
The input button flashes. (The RM SET
UP button remains lit.)
Press SHIFT, then press the
numeric buttons (button 1 in
the example) you want to store
the new command.
The input button you selected in step 2
lights up. (The RM SET UP button
Point the remote code receiver
section of the remote toward
the receiver/transmitter on the
remote commander to be
While the second remote is receiving the
signal, the input button selected in step 2
The RM SET UP button flashes twice,
then the learning process is completed.
When the learning process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
Press RM SET UP to finish the
Learning function process.
• When the memory capacity for storing remote
commander codes reaches a certain limit, the RM
SET UP button flashes 10 times, and then the
learning process ends.
• If the RM SET UP button flashes five times in step
1, and the learning process does not start, replace
the batteries with new ones.
To cancel learning
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
About 5 cm - 10 cm (2" - 4")