Siemens SINUMERIK 828D Function Manual page 65

For the following settings, p0728 must be changed to define a terminal as input or output:
Terminal
X122.2
X122.4
X122.9
X122.10
X122.12
X132.9
X132.10
Safety Integrated
Function Manual, 07/2012, 6FC5397-3EP40-3BA0
Signal
OFF3 is not connected.
Emergency Stop is connected via SS1.
Start test stop
Test stop due
SOS selected
SS1 active
SLS limit 2 active
Line Module ready for switching on.
Example of commissioning with SINUMERIK 828D
5.6 SINUMERIK 828D control system
Parameters in the drive
p0849[0]=2
OFF3 at BICO1 for Motor Modules
p9705 = CU: r0722.3 for all drives
p0738 = CU: r9723.0 for all drives
p0739 = CU: r9722.11
p0740 = CU: r9722.1
p0742 = CU: r9722.10
p0743 = CU2: r0899.0 (default setting)
65