Configuring Connections - Siemens SIMATIC CP 541 Manual

5.2

Configuring Connections

Introduction
DP Connection
SINEC L2 in
Redundant
Configuration
Summary of this
Section
Communications Processor CP 541
EWA 4NEB 812 6188-02
This chapter contains instructions on assigning parameters to the CP 541 for
operation with S5-95F or S5-115F.
Instructions on installing a DP connection can be found in Section 4.3. The
DP connection is always non-safety-related.
Operation of a SINEC L2 in redundant configurations is possible without
restrictions (see Section 5.4).
Section
5.2.1 Configuring a Safety-Related PLC-PLC Connection
5.2.2 Configuring a Non-Safety-Related PLC-PLC Connection
5.2.3 Configuring the Safety-Related Broadcast Mode
CP 541 with S5-95F/S5-1 15F
Contents Page
5-6
5-7
5-8
5-5