Table of Contents
Advertisement
Preface
Other Pertinent
Manuals
Structure of this
Manual
Standards
Queries
iv
This CP 541 Manual describes the SINEC L2 interfacing of the CP 541.
The assigning of parameters to the programmable controller connected to the
CP 541 as a SINEC L1 slave can be found in the relevant manual.
The description of SINEC L2-DP and a DP master, such as the IM 308-C
master interface module, are not part of this Manual. Further information on
this topic can be found in the manual: ET 200 Distributed I/O System.
Detailed information on SINEC L1 can be found in the manual: SINEC L1
Local Area Network.
To facilitate rapid access to special information, the Manual contains the fol-
lowing aids:
Given at the beginning of the Manual is a full, general table of contents, a
list of figures and a list of tables contained in the entire Manual.
In the chapters, the left column of each page provides a summary of the
contents of the section.
The appendices are followed by a glossary in which the important techni-
cal terms used in the Manual are defined.
Given at the end of the Manual is a detailed index which allows rapid
access to the desired information.
The CP 541 is based on PROFIBUS Standard DIN 19245 and PROFIBUS DP
Standard DIN E 19245, Part 3.
In the event of queries on the CP 541, please consult:
Hotline SIMATIC
Nuremberg
Tel: 0911/895-7000
Fax: 0911/895-7001
In the event of queries or remarks relating to the Manual, please fill out the
correction sheet and return it to us. You will find it at the end of the Manual.
Communications Processor CP 541
EWA 4NEB 812 6188-02
Advertisement
Table of Contents
