Table of Contents
Advertisement
Assigning Parameters to the CP 541 for
the Connections
Introduction
Connections
Summary of this
Chapter
Communications Processor CP 541
EWA 4NEB 812 6188-02
This chapter contains instructions for assigning parameters to the CP 541
with minimum complexity, for the individual connections between the con-
nected programmable controller and SINEC L2.
We will explain which parameters you must change in DB1 in the reset state.
A reset is only possible from the programmer.
Appendix B explains how to optimize the parameters in DB1.
Brief instructions are given here for the following connections:
PLC-PLC connection
Broadcast
DP connection
Section
4.1
Configuring a PLC-PLC Connection
4.2
Configuring the Broadcast Mode
4.3
Configuring a DP Connection
Contents
4
Page
4-2
4-3
4-4
4-1
Advertisement
Table of Contents
