Model 706 Transmitter Configuration; Configuration Information - Magnetrol Eclipse 706 Operating Manual

32

4.0 Model 706 Transmitter Configuration

Although the ECLIPSE Model 706 transmitter can be
delivered pre-configured from the factory, it can also be eas-
ily reconfigured in the shop or at the installation using the
local LCD/Keypad. Bench configuration provides a conve-
nient and efficient way to set up the transmitter before
going to the tank site to complete the installation.
NOTE: The transmitter can be configured without the probe. Please
disregard the "No Probe" diagnostic indicator that will appear.

4.1 Configuration Information

To utilize the QuickStart menu available on the
ECLIPSE Model 706, some key information is required
for configuration.
Gather the information and complete the following operating
parameters table before beginning configuration.
NOTES: The QuickStart menu is available for Level Only applications.
1. Refer to Section 4.5 for configuration menus for Interface,
Volume or Flow applications.
2. These configuration steps are not necessary if the transmitter
was pre-configured prior to shipment.
display Question
Level Units What units of measurement will
be used?
(inches, millimeters, centimeters,
feet or meters)
Probe Model What probe model is listed on
the model information?
(first three digits of probe
model number)
Probe Mount Is the probe mounted NPT, BSP,
or flange? (Refer to probe model.)
Probe Length What probe length is listed on
the probe model information?
(last three digits of the probe
model number)
Level Offset The desired level reading when
the liquid is at the tip of the probe.
Dielectric Range What is the dielectric constant
range of the process medium?
BE57-646 ECLIPSE Guided Wave Radar Transmitter - F
answer
_____________
_____________
_____________
_____________
_____________
_____________
fieldbus ™
OUNDATION