Model R86 Transmitter Configuration; Configuration Information - Magnetrol PULSAR MODEL R86 Installation & Maintenance Instructions Manual

26 ghz pulse burst radar level transmitter with foundation fieldbus output
Hide thumbs Also See for PULSAR MODEL R86:
Table of Contents

Advertisement

32
4.0

Model R86 Transmitter Configuration

Although the PULSAR Model R86 transmitter can be
delivered pre-configured from the factory, it can also be
easily reconfigured in the shop or at the installation using
the local LCD/Keypad. Bench configuration provides a
convenient and efficient way to set up the transmitter
before going to the tank site to complete the installation.
NOTE: The transmitter can be configured without the antenna con-
nected. Disregard any diagnostic indicators that may appear.
4.1

Configuration Information

To utilize the DEVICE SETUP/BASIC CONFIG menu
available on the PULSAR Model R86, some key informa-
tion is required for configuration.
Gather the information and complete the following operating
parameters table before beginning configuration.
NOTE: These configuration steps are not necessary if the transmitter
was pre-configured prior to shipment.
Display
Measurement What is the intended measurement
Type
System
Units
Antenna
Model
Antenna
Extension
Antenna
Mount
Heat
Extension
Tank Height
Stillwell ID
Dielectric
Range
Turbulence
Foam
Rate of
Change
58-641 PULSAR Model R86 Pulse Burst Radar Transmitter - F
Question
type (Level, Volume, or Flow)?
What units of measurement will be
used?
What type of antenna is being used?
Select first 3 digits of model number.
(See nameplate on side of antenna.)
What is maximum nozzle length for
which the antenna can be used?
Select 11th digit of antenna model number.
(See nameplate on side of antenna.)
Is the antenna mounting NPT, BSP,
or flanged?
Is there a heat extension connected
to the antenna?
What is the tank height?
What is the Inner Diameter (ID).
Enter 0 if not applicable.
What is the dielectric of the process
medium?
What amount of turbulence is expected? _____________
What amount of foam is expected?
What is the expected maximum rate
of level change?
OUNDATION
Answer
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
fieldbus
Instruction Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pulsar r86

Table of Contents