Procedure
1. Screw the lifting eyes (eyebolts) in at appropriate locations for the orientation of the motor
during transportation.
2. Hook the beam into the lifting eyes (eyebolts).
Figure 7-2
3. Set the motor down on a hard, level surface.
4. Secure the motor against unintentional movements.
❒
1FK2 synchronous motors for SINAMICS S120
Configuration Manual, 06/2019, A5E46927724B AB
Transporting the motor with a beam (example)
WARNING
Danger of severe injury due to unintentional movements of the motor
If the motor is not secured after being set down, unintentional movements of the motor
can cause serious injury.
• After the motor has been set down, secure it in position.
• Do not release the lifting devices until the motor has been secured in position.
Preparation for use
7.1 Transporting
95